kickflip

I’m sorry, flying cars!????

Tesla rolled a Roadster over in mid-air on compressed air. This is an engine that could do it, sized on paper from only the numbers given on stage, and the check of whether it closes.

Mechanical engineering
Thermodynamics
Python
CoolProp
~1 s
of full thrust

of full 80 kN thrust from one cold, regulated fill of 250 kg of air.

~13%
of the fill

of that fill spent on a 180° roll. The flip is the cheap part.

83 / 76
kN·s

kN·s one run needs against what the tank gives. Halve the hover and it fits, once.

What was shown

On 15 October 2026, at SpaceX's test site in McGregor, Texas, Tesla launched an unmanned Roadster off a curved ramp. In the air it rolled about its long axis and landed on its wheels; a second run cleared a line of cars and a Semi. Nothing burns: the thrust is compressed air let out through nozzles, the cold-gas idea spacecraft use to point themselves.

ClaimValueSaid by
Nozzles10, on the top trimTesla
Tankstwo, carbon-overwrapped, 600 L in allLars Moravy, on stage
Air aboardabout 250 kgreported
Peak thrust80 kNreported, from Tesla
Thrust against tyresfour to five times what the tyres can pushTesla
Fan suctionup to 2 gTesla
0–60 mph0.81 srun live
By trimunder 1.6 s with fans only, 0.9 s with rear thrusters, 0.59 s with the full systemTesla
Not givencar mass, tank pressure, airtime, thrust per nozzle

The figures check each other. If 80 kN is four to five times the tyres' push, the tyres manage 16 to 20 kN, roughly 1 g for a 1,900 kg car, which is what good road tyres give.

How it works

  1. Store: two tanks, 437 bar
    250 kg of air in 600 L. Real-gas air, not the 351 bar an ideal gas would suggest.
  2. Carry: one trunk, three regulators
    Full tank pressure down a 15 cm trunk, dropped to 30 bar right beside each nozzle group.
  3. Expel: ten cone nozzles
    Sonic at a 6.7 cm throat, out of a 12.8 cm mouth at 553 m/s, a specific impulse of 56 s.
  4. Fire: pulse the valves
    Ten valves, open or shut. The flight computer pulses them in a closed loop on an inertial sensor.
The engine · layout
Ten nozzles in three jobs
TOPR1R2R3R4L1L2L3L4F1F20.75 mSIDERLLF4.3 m
nozzlesfireseachjob
R1–R4aft15 kNlaunch
L1–L4down15 kNlift, landing, roll
F1–F2sideways5 kNyaw, drift
A generic low coupe, top and side, to scale. Four rear nozzles push; four under the corners lift, cushion the landing and, fired one side at a time, roll the car; two at the front stop yaw and drift. Dashed circles are on the underside.
The engine · plumbing
Stay at tank pressure until the last moment
tank A300 Ltank B300 Lisolation437 bar, 20 °C250 kg of airtrunk 15 cmreg30 bar outrear4 × 15 kNreg30 bar outlift4 × 15 kNreg30 bar outfront2 × 5 kNflightcomputer+ inertialsensorvalve opensin < 20 ms
Both tanks feed one isolation valve and a single 15 cm trunk at full pressure. Each group has its own regulator beside it, dropping to 30 bar, and each nozzle its own fast valve. The flight computer works the ten valves on an inertial sensor and never touches the regulators.
The engine · one 15 kN nozzle, to scale
Fist-sized, and nearly as cold as liquid oxygen at the exit
Ø 11.7Ø 6.7Ø 12.8 cminlet30 bar−18 °Cthroat15.7 bar−62 °CMach 1exit1.0 bar−178 °C553 m/s11.4 cm, 15° half-angle
A cone sized for 30 bar in and atmospheric out. At the start of a burn the air leaves at 553 m/s and −178 °C, 13 degrees above where it would liquefy, and that margin sets the flare. Later, colder air would frost a real nozzle; a heater on the wall is the cheap fix.
The engine · one kickflip run
Ten valves, four phases, about three seconds of air
open
pulsing
launch0.81 srampfansroll1 shover1 sland0.49 srear R1–4lift L1 L2lift L3 L4front F1 F2about 3.3 s of firing in all
Rear nozzles launch, then all shut while the fans carry the car up the ramp. Off the ramp the left lift pair starts the roll and the right pair stops it. All four pulse to hover (one second here) and open fully for half a second to land; the front pair only taps.

Key decisions

130 kN of nozzles on an 80 kN feed

80 kN is treated as the most the tanks and lines can feed at once. No phase needs every group together: the launch uses the rear four, the landing the lift four. Sizing each group near the feed limit gives each phase the full flow.

Roll from the corners, not the nose

Reports put two nozzles at the front for turning the car upright. Here the corner pairs do it, because a pair on one side rolls the car without tipping its nose. The front pair only stops yaw and drift.

No heater

Keeping the tanks at room temperature would add two thirds more impulse, but it means 28 MJ in under two seconds, about 18 MW. Warming only the flow after the regulators still takes 5.6 MW. The whole drivetrain is rated at 1 MW, so the engine accepts the cold.

Regulated, not straight blowdown

Straight off the tank, thrust halves in 0.56 s and the car is hard to steer. A 30 bar regulator holds thrust near 80 kN for about a second, then gives out with 74 kg of air still aboard. The nozzle flare is capped by frost, not efficiency: expand further and the air starts to liquefy.

Results

Blowdown · 250 kg of air, 600 L of tank
Held at 80 kN, the air lasts about a second
regulated, cold tank
regulated, heated tank
straight blowdown
020406080012345seconds of firing, all nozzles openthrust, kN
at
0.50 s
thrust
78.5 kN
tank
167 bar
tank gas
-46 °C
air left
171 kg

total impulse 76 kN·s from 176 kg · 74 kg stranded · stops because regulator dropout

Thrust from full tanks for three ways of plumbing the same air; drag to read the tank at any moment. Straight off the tank, thrust collapses with pressure. A 30 bar regulator holds it near 80 kN until the cooling gas gives out with a third still aboard. A room-temperature tank, the upper bound, adds two thirds more. Real-gas air from CoolProp.
The roll · bang-bang, spin up then spin down
Turning the car over costs about an eighth of the tank
roll angle
0°90°180°270°360°0.000.501.00seconds into the burn90° turned
thrust, one side
9.6 kN
torque
7.2 kN·m
impulse
9.6 kN·s
of the tank
13%

roll inertia 575 kg·m² · a valve 20 ms late leaves 14°/s of spin · tank budget 76 kN·s, regulated and cold

One side spins the car up for half the burn and the other stops it (shaded), so it arrives with no roll left over. Set the angle the thrusters must turn (the ramp does the rest), the time and the mass; drag to watch the car end on. Radius of gyration 0.55 m and lever arm 0.75 m are estimates.
The ledger · one run, in impulse
One stunt drains the tank
020406080100120140 kN·slaunch 250–60 in 0.81 sroll 10180° in 1 shover 19one secondlanding 29from about 8 mregulated, cold 76blowdown 86heated 127
The impulse each part of a run needs, stacked against what one fill delivers under each design. A cold regulated tank comes up a little short; a straight blowdown has more in total but cannot hold the landing thrust. Assumes a 1,900 kg car and an apex about twice the Semi's 4.1 m; every bar scales with the mass.
Worked outResult
Fill pressure (outside estimate about 440 bar)437 bar
Tanks at Toyota Mirai carbon-tank ratesabout 270 kg
Flight system with air380 to 520 kg
Impulse, cold and regulated (warm upper bound 127)76 kN·s
Tank gas temperature late in a full burntowards −120 °C
180° roll in a second, per sideabout 10 kN
Valve shut 20 ms late14°/s of leftover spin
One run: launch, roll, hover, landingabout 83 kN·s
One refill, ideal compressor / real36 / about 70 kWh

The flip spends about 13% of a cold regulated fill, and a full 360° about a quarter. Timing matters more than force, which is why the car must close the loop on its own attitude rather than fire to a schedule. What fights gravity or adds speed is expensive: hovering costs the car's whole weight, about 19 kN, every second. A refill costs a few hundred kilometres of driving in electricity and hours on a carryable compressor, so the thrusters are for the track.

Where it stands

The engine nearly closes. A full run needs about 83 kN·s and a cold fill gives 76; halve the hover and ten nozzles, a trunk, three regulators and ten fast valves do the stunt on 250 kg of air, once per fill. Tesla's numbers hang together. The constraint is the tank, not the flip.

Three things would sharpen this: the car's mass, the airtime measured off the footage, and the real thrust per nozzle. Each changes the ledger directly.

The blowdown runs a real-gas model of air (CoolProp) in research/kickflip/blowdown.py, and the engine is sized from it in research/kickflip/engine.py; the roll and the ledger come from the formulas in each figure's source. Car mass (1,900 kg), roll inertia (radius of gyration 0.55 m), lever arm (0.75 m), the 30 bar regulators and the nozzle layout are this design's choices, not Tesla's figures.